Included Items; Technical Information; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside PPHSS 730 Bedienungs- Und Sicherheitshinweise

Included items

Q
1 Pendulum-action jigsaw including
- Dust extraction spout
- Allen key
- Chip guard
1 Guide fence
1 Plastic case
1 Operating instructions
1 "Warranty and service" booklet
2 Saw blades for wood
1 Saw blade for metal

technical information

Q
Jigsaw:
Rated voltage:
Power consumption:
no-load speed:
Cutting depth:
Pendulum action:
Inclined cut:
Protection class:
noise and vibration data:
Values determined in accordance with En 60745.
The sound pressure level (A-weighted) of the
device is typically 90 dB(A). Uncertainty K=3 dB.
The sound level while working can exceed 101 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1,5 m / s
WArnIng!
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in En 60745 and can be used to compare devices.
Introduction / General safety advice for electrical power tools
Parkside PPHSS 730
230 V ~ 50 Hz
730 W
max. n 600 - 2900 min
-1
0
max. 110 mm
3 speeds and a fine
cutting setting
0 - 45° left / right
II /
= 6,268 m / s
2
2
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool is
used regularly in particular circumstances.
note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actual-
ly in use. This can result in a much lower vibration
load over the whole of the period of working.
general safety advice for
electrical power tools
read all the safety advice
WArnIng!
and instructions!
Failure to observe the safety advice and instructions
may result in electric shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AnD InSTRUCTIOnS
In A SAFE PLACE FOR FUTURE REFEREnCE!

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b) Do not work with the device
in potentially explosive en-
vironments in which there
are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
GB/MT 27