AVS Electronics OUTSPIDER PA WS Bedienungsanleitung Seite 37

Sensor opening and board removal
1.
first lift the bottom part
2 (1) and then unhook it
from the upper part of
the guide (2).
2.
two set screws.
A A
3.
Slide the board until the
notches
the stops
4.
Remove the board.
To remove the cover,
1
Remove the
B
A
coincide with
B
.
Wall and pole plate installation
Holes for fixing the
plate to the wall
Holes for fixing the plate
to a pole with adaptor
Installation of the joint
Assemble and fasten using
the Screw D and the Nut E
the various pieces that make
B
up the joint, as shown in figure,
before fixing the Wall side
bracket A to the wall.
For passing connection
cables and those of the
anti-tampering module,
use the existing space
above the Screw D
- 37 -
mod. SP-OUT
(item 1135106)
Insert the washer F
into the screw D
D
C
B
F
ATTENTION
ATTENTION
Before fixing the
Position the Sensor side
wall joint, install the
joint C verifying that the
anti-tampering
45° notch is on the
bottom and the 90° one
is on the top
E
N
G
A
E
module