Checking The Used Time; Setting The Mode At The End Of The Tape - Sony SVT-72P Bedienungsanleitung

Checking the Used Time

1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "7" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The POWER FAILURE/DEW/USED HOUR
menu appears.
2 0 1 2
DEW
ON 1 0 – 1 2
0 1 5 OFF 2 0 – 1 2
USED HOUR
V I DEO HEAD 0 0 0 0 0 H
POWER ON 0 0 0 0 0 H
< >
NEXT PUSH
RETURN : MENU
VIDEO HEAD: the amount of time the video head
has been used.
POWER ON: the amount of time the power has
been on.
4
Press SEARCH to return to the normal display.
0 7 : 3 0
1 1 : 0 0
1 2 : 0 0
Setting the Mode at the End of
the Tape
You can set the mode of the tape operation when the
tape comes to the end during recording in the
GENERAL SET menu.
When the REPEAT REC switch is set to OFF
1
1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "4" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The GENERAL SET menu appears.
4
Press MENU V to move the flashing to the setting
of TAPE END MODE and set to REW or STOP by
pressing MENU + or –.
GENERAL SET
TAPE IN MODE STOP
TAPE END MODE REW
TAPE USED COUNT OFF
CLOCK ADJUST 0 1 : 0 0
APC ON
THREAD CHECK OFF
T/D SEARCH CONVENTION
BAUD RATE 1 9 2 0 0
< >
NEXT PUSH
+
–
SELECT : DATA SET : / RETURN : MENU
REW: when the tape comes to the end, the VCR
rewinds the tape automatically and enters stop
mode at the beginning of the tape.
STOP: when the tape comes to the end, the VCR
enters stop mode at once.
5
Press SEARCH to return to the normal display.
Note
Even if TAPE END MODE is set to STOP, the VCR
operates according to the settings of ALARM DATA REC
and/or TAPE USED COUNT if those settings are set to ON.
2-4 5
23