General Instructions - Casualplay S4 Anwendungshinweise

GENERAL INSTRUCTIONS

UNFOLDING ThE ChASIS (see illustrations 01 - 04)
• Operate the pushbotton and release the chassis opening mechanism.
• Release the chassis by strongly turning the handlebar upwards.
• The front wheel will release itself and automatically remain fixed. Check it is
fastened.
• Check that the safety anchor remains in the position shown in the photo.
Attaching the wheels (see illustrations 05 - 08)
• To mount the rear wheel, insert the wheel's stud bolt in the socket by processing
continually on the button and check the wheel has been correctly mounted by
spinning it (fig. 05).
• To mount the back wheel place the axis of the chassis in the wheel socket (fig. 06).
• To remove the back wheels press the button on the centre of the wheel and pull
it out (fig. 07).
• To remove the front wheel press the button located under the wheel socket and
pull the wheel out at the same time (fig. 08).
Legrest (see illustrations 09 -11)
• To extend the leg rest, lift the lower part of the seat up (fig.09).
• Put the piece found under the seat (fig.10), into its locking position (fig.11). It will
click when correctly fastened.
• To go back to the original position, unlock the piece and lower the leg rest.
Operating the brake (see illustrations 12 - 13)
• Phus down firmily to apply (fig. 12). After applying the brake chek it by gently rock-
ing the pushchair backward and forward. Lift to release. The provisional hand-
brake can also be used (fig. 13).
CENTRE ThE BRAKE (ACCORDING TO ThE MODEL): TURN ThE KNOB (FIG. 14).
harness adjustment and fastening the buckle (see illustrations 15 - 16)
• To fasten the buckle (fig. 15) place part A inside part B by pressing untill you hear
a "click" sound (fig. 16). To open press the mail buckle sides and pull it out.
Restraint
• The harness is attached to the seat unit. Ensure the straps are adjusted to the size
of your child using adjusters C (fig. 16), and that the waist belt is fed through the
crotch strap as shown.
Assembling the pushchair padding (see illustrations 17 - 20)
• Remove the cushions from the seat cover (fig. 17).
• Open the buckle (fig. 18).
• Place the mat on the pushchair and run the harness straps through the openings
on the mat as shown in the photo (fig. 19).
• Assemble the protectors by fastening the velcro. The chest protectors should be
positioned so that the stitching does not come into contact with the child (fig. 20).
Adjusting the handlebar (see illustrations 21 - 22)
• To adjust the handlebar press the button in the middle (fig. 21) and place it in the
position you wish (fig. 22).
10