Waeco PerfectView CAM60 Einbau- Und Bedienungsanleitung Seite 33

_CAM60.book Seite 33 Dienstag, 22. Dezember 2009 5:02 17
PerfectView CAM60
Connecting the camera
NOTE
I
Lay the camera cable so that should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This considerably
eases dismantling work.
To minimise corrosion in the plug, apply a small amount of
grease – such as pin grease – inside the plug.
Additional extension cables are available on request
(see chapter "Accessories" on page 26).
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable
(fig. g A, page 6).
NOTICE! Risk of damage!
A
The plug connections of the extension cable do not offer any
protection against water penetration. It is essential that you wrap
the connection with the sealing tape supplied (fig. g B, page 6).
Aligning the camera
NOTE
I
If necessary before aligning the camera connect the camera to a
monitor and to a power supply (see connecting diagram, fig. h,
page 6
➤ Use the monitor image to align the camera:
The monitor image should show the bottom edge of the rear or the
bumper of your vehicle (A). The middle of the bumper should be in the
middle of the screen. (fig. i, page 6).
➤ Check the function of the camera after you have connected it to a monitor.
Fastening the camera
➤ Thighten the two screws in the slots of the camera bracket.
➤ Mount the side covers with the two screws M3 x 8 mm in the middle drill
holes (fig. j, page 7).
Mounting the camera
33