Safe Working - LIVARNOLUX LSL 32 A2 Bedienungs- Und Sicherheitshinweise

or lacking experience and / or knowledge, so
long as they are supervised or instructed in the
safe use of the appliance and understand the
associated risks.
Never allow children to play with this device.
Cleaning and user maintenance should not be
performed by children without supervision.
DANGER TO LIFE! During installation keep
children away from the area in which you are
working. A large number of screws and other
small parts are included with delivery. These
may prove life-threatening if swallowed or in-
haled.
EXPLOSION HAZARD! Do not
operate the light in potentially explo-
sive environments containing flam-
mable vapours, gases or dusts.
Do not expose the light to direct sunlight, rain,
snow or ice. The product may otherwise be
damaged.
The light may be mounted to any normally in-
flammable surfaces.
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, per-
forms the electrical installation.
Never use the light if any defects have been
identified.
In the event of damage, repairs or other prob-
lems with the light, please contact the service
centre or an electrician.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Prior to installation, remove the fuse or switch
off the circuit breaker 0 setting in the fuse box.
Prior to installation verify the mains voltage on
site corresponds with the operating voltage re-
quired for the light (100–240 V∼).
Be careful not to damage lines during installation.
Prevent fire and
injury hazards
RISK OF INJURY! Check every bulb and
lampshade for damage immediately upon un-
packing. Do not fit the light if the bulbs and / or
lampshades are faulty. In this case contact the
service centre for a replacement.
DANGER OF ELECTRIC SHOCK! DANGER
OF DAMAGE TO PROPERTY! RISK OF
INJURY! Please be sure not to drill into any
electrical wiring, gas or water lines inside the
wall. If necessary, use a cable detector before
drill into the wall.
FIRE HAZARD! Fit the light so that
it is at least 1 m away from the mate-
1 m
rial to be illuminated. Excessive heat
can result in a fire.
Broken glass must be replaced be-
fore using the light again.
The bulbs cannot be replaced.
Do not look directly into the light source (light
bulb, LED etc.).
To prevent burns, verify the light is switched off
and has cooled down for at least 15 minutes
before touching it.

Safe working

Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
at all times. Never install the light if you are
having difficulty concentrating or do not feel well.
Safety notices
GB 7