Camera Setting - AKASO V50 Elite Touch Handbuch

3. Time Lapse Interval: Unlimited / 3 Sec / 5 Sec / 10 Sec / 30 Sec / 1 Min
Default setting is Unlimited.
Time Lapse Photo captures a series of photos at specified intervals. Use this mode to
capture photos of any activity, then choose the best ones later.
Note: Time Lapse Photo is disabled when Burst Photo is on.
4. Time Lapse Duration: Unlimited / 5 Min / 10 Min / 15 Min / 20 Min / 30 Min / 60 Min
Default setting is Unlimited.
Note: If you want to set Time Lapse Duration, please turn on Time Lapse Interval first.
5. Night Lapse: On/ Off
Default setting is Off.
Captures a series of photos at specific intervals and exposure times. Use Night Lapse in
low light environments, such as when capturing the night sky over a period of time.
6. Burst Photo: Off, 3 shots / 1s, 7 shots / 2s, 15 shots / 4s, 30 shots / 8s
Default setting is Off.
Burst captures up to 30 photos in 8 seconds, so it is perfect for capturing fast-moving
activities.
7. Delay Timer: Off / Delay 3s / Delay 5s / Delay 10s / Delay 20s
Default setting is Off.
A delay timer gives a delay between pressing the shutter release and the shutter's firing. It
is most commonly used to let photographers to take a photo of themselves (often with
family).
8. Long Exposure: Off / 1 Sec / 2 Sec / 5 Sec / 8 Sec / 30 Sec / 1 Min
Default setting is Off.
Long exposures are easiest to accomplish in low-light conditions, but can be done in
brighter light using neutral density filters or specially designed cameras.
Note: Long Exposure is disabled when Burst Photo is on.
9. RAW: ON / OFF
Default setting is OFF.
11
10. Photo Scene Mode: Manual, Indoor, Outdoor, Portrait, Landscape, Night
Default setting is Manual.

Camera Setting

1. Sounds
Shutter: On / Off Boot-up: On / Off
Beep: On / Off Volume: 0 / 1 / 2 / 3 Default setting is 2.
Default setting is on.
You can turn on or off the shutter, boot-up, beep sounds.
2. BT: On/ Off (Remote)
Default setting is Off.
You can also hold and press Down button for three seconds to turn on BT. Press Mode
button to turn off BT.
3. Distortion Calibration: On / Off
Default setting is Off.
Turn on Distortion Calibration, it can correct the image distortion.
Note: Distortion Calibration is disabled when you select 4K 60FPS video resolution.
4. Special Effect: None, Black&White, Sepia, Vivid, Natural, Negative, Warm, Cold, Red,
Green, Blue
Default setting is None.
5. Diving Mode: On / Off
Default setting is Off.
Turn on Diving Mode, it can compensate for the lack of red light in underwater scenes.
Diving Mode is designed to be used in tropical and blue water, optimized for use between
10 and 80 feet.
6. Date Stamp: Off / Date / Date&Time
Default setting is Off.
If you select Date&Time, this camera adds date and time to the video or photos you take.
Note: Date Stamp is disabled when Image Stabilization is on.
12