Abicor Binzel MFS-V2 Betriebsanleitung Seite 34

6 Putting into operation
Danger of crushing
Limbs can be drawn in and crushed.
• Do not reach into moving wheels.
NOTICE
• Please take note of the following instructions:
• The system may only be installed and put into operation by authorized personnel (in Germany see
6.1 Installation
Select a location that allows a short and rectilinear wire feed.
6.2 Connecting the control leads
Connect the control leads using the following procedure:
1 Interface X41
2 Interface X46
3 Control lead B
4 Control lead X47
Fig. 6 Connecting the control lead
6.3 Establishing the media connections at the M-Drive
Connect the following connections to one another:
1
9
8
1 Air-blast outlet
2 Air-blast inlet
3 Gas inlet
Fig. 7 Connection diagram
EN - 10
WARNING
 2 Safety on page EN-3
TRBS 1203).
1 2
A
13
12 11
5 Interface X48
6 Interface 49
7 Control lead C
7
4 Welding cable connection
5 Coolant return inlet
3
4 5
6
B
E
C
7
10 9 8
8 Interface X43
9 E-Box
10 Interface X51
6
6 Coolant supply inlet
7 Coolant supply outlet
MFS-V2
11 Control lead E
12 M-Drive
13 Control lead A
2
3
4
5
8 Coolant return outlet
9 Cable assembly