Installation In A Server Rack - Dell PowerConnect W-3000 Series Installationsanleitung

Figure 3
7. Connect the AC power cord (country-specific) to the rear of the unit.
8. Plug the opposite end of the power cord into an electrical outlet to power on the controller.

Installation in a Server Rack

To install a W-3000 Series Controllers controller into a 19-inch (48.26 cm) Server rack system:
Note: The following instructions describe the installation of your controller in a rack with unthreaded, square holes. For a rack
with unthreaded, round holes, use the provided clip nuts instead.
1. Place a rack mount bracket over the mounting holes on one side of the controller (see
2. Secure the bracket to the controller using three 6-32 x 1/4" phillips head screws and a suitable screwdriver.
3. Repeat these steps on the opposite side of the controller.
4. Install the four cage nuts.
a. Begin by inserting the lower lip of the cage but over the square opeing in the back of the rail.
b. Insert the small end of the cage-nut installation tool through the opening in the rail (from the front), and
hook the tool over the top lip of the cage nut.
c. Push the cage nut in towards the rail while rotating the tool up and pulling the tool back toward you until
the top lip of the cage nut snaps into position.
5. Mount the controller within your organization's rack system using four M6 x 20mm phillips head screws and
suitable screwdriver.
6. Leave a minimum of four inches (10cm) of space on the left and right side of the unit for proper air flow and
ventilation (see
7. Leave additional space in front and back of the unit to access power cords, network cables, and LED status
indicators (see
8. Connect the AC power cord (country-specific) to the rear of the unit.
9. Plug the opposite end of the power cord into an electrical outlet to power the controller.
Note: W-3000 Series Controllers do not have a power on/off switch. Power to the unit is controlled by inserting (or unplugging) the
power cord plug into your electric outlet.
Dell PowerConnect W-3000 Series Controller | Installation Guide
Air Flow Requirements
4 inches (10
cm) Minimum
Keep Clear for
Air Exhaust
Figure 3).
Figure 3).
Keep Clear for Air Intake
Keep Open for
Easy Access
Keep Open for
Easy Access
Figure
Installing the W-3000 Series Controllers |
1).
15