Attaching / Removing The Accessory - Parkside PWSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

1. Adjust the guard
7
detached parts cannot hit either the user or
any bystanders.
2. The guard must also be positioned such
7
that the sparks cannot ignite combustible
parts, including those in the surroundings.
3. Turn the guard
7
the clamp should match the notches on the
guard .
7
Attaching / removing the
Q
accessory
WARNING!
Always remove the battery pack from the
u
product before changing the accessory in
order to avoid switching it on accidentally.
Always use the correct accessories according
u
to the intended use! Observe the technical
requirements of this product (see section
Technical data) when purchasing and using
accessories!
Accessories can be sharp and become hot
u
during use! Handle them carefully! Wear
safety gloves when handling accessories in
order to avoid injuries like burns and cuts!
Never press the spindle lock whilst the
u
spindle is rotating!
The arrow on the accessory must correspond
u
to the arrow showing the direction of rotation
(running direction shown on the product).
Ensure that the accessory is suitable for the
u
rotational speed of the product.
Do not use any saw blades.
u
such that any sparks or
to the required position so
CAUTION! RISK OF INJURY!
Only use accessory recommended by the
u
manufacturer. Using other attachment tools
and other accessories can represent a risk of
injury for you.
Only use accessory, which bear information
u
about the manufacturer, type of binding,
dimension and permitted number of
revolutions.
Only use grinding discs where the printed
u
rotational speed is at least as high as what
has been specified on the product marking.
Do not use any broken, cracked, or otherwise
u
damaged accessories.
Only use flawless grinding discs (ringing
u
test: when you strike the disc with a plastic
hammer, it results in a clear sound).
Ensure that the accessory dimensions match
u
those of the product.
Never re-drill a locating hole which is too
u
small to make it larger.
Never use separate bushings or adapters in
u
order to make discs with a hole that is too
large fit the product.
Never operate the product without protective
u
equipment.
Support plates or workpieces to reduce the
u
risk of kickback from a jammed disc. Large
workpieces may bend under their own
weight. The workpiece must be supported on
both sides of the disc, near the disc as well
as at the edge.
Always reassemble the product completely
u
after replacing accessories.
1. Press and hold the spindle lock button
2. Release the locking flange
key .
5
3. Mount the desired accessory onto the
backing flange
9
the product.
4. Mount the locking flange
5. Press and hold the spindle lock button
and tighten the locking flange
using the chuck key
.
10
, with the chuck
8
. Label should always face
8
on the spindle.
10
tight again
8
.
5
GB / CY 15