Malfunctions - diversey Taski swingo 2500 Anleitung

Malfunctions

Malfunction
Machine without function
Brush unit or suction unit cannot be
turned off
Brush does not rotate
Poor suction performanceFloor re-
mains wetDrain water is not
absorbed
Suction unit switches off
Insufficient cleaning solution supply
Possible causes
Machine is switched off
Emergency switch is pressed
Main fuse is defective
Error code on the display
Immobilizer activated or fault in the
controls
Gas pedal pressed during switch-on • Release the gas pedal and try
Stopping brake interlocked
Battery discharged or defective, Bat-
tery charger defective
Batteries defective
Error in the electronic system or in
the control panel
Brush drive switched off
Main fuse is defective
Motor rotates, brush does not
Suction unit switched on
Suction hose not connected
Suction nozzle not on the floor
Blades worn out
Hose or suction nozzle clogged (e.g.
pieces of wood, remnants)
Suction filter clogged
Suction unit indicator lights up but
vacuum cleaner is not running
Recovery tank full
Recovery tank contaminated
Cleaning solution tank empty
Cleaning solution volume set too low
Cleaning solution button switched off • Press cleaning solution button
Clean intake
Troubleshooting
• Turn the key
• Connect the battery switch with the
machine
• Check/replace fuse
• Contact your service partner
• Contact your service partner
• Sit down on the driver seat
switching on the machine again
• Unlock the stopping brake.
• Load batteries
• Contact your service partner
• Contact your service partner
• Stop the machine using the battery
disconnection socket
• Contact your service partner
• Press Brush button
• Replace fuse
• Drive belt broken
• Contact your service partner
• Press suction unit button
• Connect suction hose
• Check suction nozzle suspension
for functionality
• Replace blades
• Remove any foreign matter
• Remove any foreign matter
• Check fuse and replace it, if nec-
essary
• Fuse is OK, contact your service
partner
• Drain recovery tank
• Check battery monitoring
• Check fuse
• Check recovery tank and clean it, if
necessary
• Check cleaning solution tank
• Adjust cleaning solution volume
with +/- buttons
• Filter
Page
60
60
EN
63
63
63
60
63
63
68
60
63
66
66
65
60
60
69