Start-Up; Switching On And Off; Releasing The Plunge Blocker; Preselect Cutting Depth - Parkside PTS 480 A1 Originalbetriebsanleitung

If you work outside, connect the device to a
residual current (RCD) protective switch with
a maximum 30 mA tripping current. Only use
extension leads approved for outdoor use.
Note: Always hold the mains cable out of the op-
erating range of the machine and move it towards
the back of the machine.

Start-up

Switching on and off

Switching on:
Pull the ON / OFF switch
(see Fig. A).
Switching off:
Release the ON / OFF switch

Releasing the plunge blocker

Push the plunge blocker
and keep it pressed.

Preselect cutting depth

Note: We recommend adjusting the cutting depth
at least 2 mm deeper than the thickness of the ma-
terial. This will result in a clean cut.
Release the quick release of the cutting depth
pre-selector , adjust the desired cutting depth
7
at the scale and refit the quick release.
7 a

Fitting the guide fence

Release the screw of the guide fence
the base plate and insert the guide fence
9
into the guide fence fixture
screws .
11 a
General safety advice for electrical power tools / Start-up
towards the back
6
.
6
towards the front
1
at
11 a
11
. Retighten these
10

Handling the plunge saw

1. Put the machine onto the material and switch it on
as described in the chapter "Switching on and off".
2. If necessary adjust the machine to the guide
fence or a drawn line.
11
3. Hold the machine as shown in Figure A and
cut with light pressure.
Types of saw blades:
The saw blades included cover the most common
types of application.
HW Circular saw blade
Description: ø 85 mm, 30 HW-teeth
Suitable for: Soft wood, hard wood, boards of any type
Diamond cutting disc
Description: ø 85 mm, without teeth
Suitable for: Ceramics, plastics
HS Circular saw blade
Description: ø 85 mm, 36 teeth – tooth setting
left / right
Suitable for: Soft wood, soft metals such as aluminium,
copper

Marking cutting length

Orient yourself at the markings for the cutting
length , in order to check where your cut
8
starts and ends.

Marking cutting line

The cutting line viewing window allows precise
guidance of the machine along the cutting line
applied to the workpiece.
In order to achieve an exact cut, place the
machine on the workpiece so that the cutting
length labelling appears in the cutting line
viewing window
12
Z85 / 30:
20
Z85VR:
21
Z85 / 36:
22
, as depicted in Illustration B.
GB 11