Placing Your Children In The Seats P; Adjusting The Rear Seat P; Storing Or Transporting The Frame P - Mutsy Duoseat Gebrauchsanweisung

English
Placing your children in the seats
! Warning: Use a harness as soon as
yourchild can sit unaided.
· Place your children in the seats and
make sure that the legs of your chil-
dren are on both sides of the crotch
strap.
· Both seats have a 5-point safety har-
ness. You operate the safety harness
by fixing all the plastic parts.
· The safety harness can be adjusted
by moving the plastic parts over the
belts and placing them in the desired
position.
Adjusting the rear seat (4+5)
· You can adjust seat 02 to 4 different
positions. In position 1, 2 and 3, the
2 back attachment clips are fastened
to crossbar D, and the metal pins are
inserted into openings 1, 2 and 3 re-
spectively (see fig. 4a). In position 4
(this is the most horizontal position),
the 2 back attachment clips are not
fixed; this means you can move seat
02 to a more horizontal position. In
position 4, you must always use the
safety belt. For position 4, the metal
pins must be in opening 3.
· You can adjust the rear seat from the
upright (sitting) position by pushing
the backrest downwards while simul-
taneously moving the bracket behind
the backrest upwards.
· The horizontal position / position 4:
- Release the 2 attachment clips under
seat 02 (crossbar D).
- You can now push the backrest of
seat 02 backwards until the foot end
of seat 02 is almost against crossbar
12
B. The metal pins should now be in
opening 3 (fig. 4 + 4a)
- Fastening the safety belt:
Pull the safety belt through the buckle
(crossbar B) (see fig.5) and then move
the safety belt over crossbar C. Now
pull the safety belt tight and fasten it in
place using the velcro-type fastening.
· You can raise the seat again from posi-
tion 4 by unfastening the safety belt
and then lifting the bracket behind the
backrest while guiding the seat to the
desired position with your other hand.
! NEVER forget to replace the attach-
ment clips.
! Always check that the back adjust-
ment is properly fixed in place! The
back adjustment section is shown in
fig. 4a.
! When you adjust seat 02 from position
4 to position 1, 2 or 3, you must always
check that the attachment clips of seat
02 have been fastened in place.
Storing or transporting the frame
· You must remove the duoseat frame
with the seats before folding the frame.
· You can also remove the hoods and-
seats to make it more compact for
storage.
· You can remove the seats as follows:
To remove the first seat, release the
four attachment clamps. You can now
remove seat 01 from the frame. To
remove the second seat, only release
the two attachment clamps at the
bottom and then guide the metal
pins through the recesses in the back
adjustment mechanism. You can now
remove seat 02 from the frame.