Original Accessories / Attachments; Preparing For Use; Switching On / Off; Setting The Cutting Depth - Parkside PEH 30 A1 Originalbetriebsanleitung

General safety advice for electrical power tools / Preparing for use
Never use the device for a purpose
for which it was not intended or with
non-original parts / accessories.
Hold the device securely when work-
ing. Ensure that you are standing in a stable,
well-balanced position.
Always keep the device clean, dry
and free from oil or grease.

Original accessories / attachments

Q
Use only the accessories and attach-
ments detailed in the operating instruc-
tions. The use of attachments or accessories
other than those recommended here could lead
to you suffering an injury.

Preparing for use

Q

Switching On / Off

Q
Switching on:
First press the safety lock-out
Then press and keep pressed the ON / OFF
switch .
2
Switching off:
Release the ON / OFF switch
Note: For safety reasons the ON / OFF switch
cannot be locked in the ON position.

Setting the cutting depth

Q
The rotary control can be used to set the cutting
13
depth in steps from 0–3.0 mm according to the cut-
ting depth scale .
14
Vacuum extraction of dust /
Q
debris (see Fig. A)
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
10 GB/IE/CY
Planing debris removal port (right / left
selectable):
External vacuum extraction:
If necessary fit the reducer piece
a dust extraction system, e.g. a workshop dust
extraction system.
The vacuum cleaner / dust extraction device used
must be suitable for the material being planed.
Connection:
.
1
. Removal:
2
2
Q
The parking shoe
down without the risk of damaging the workpiece.
When planing, the parking shoe
exposes the rear part of the sole
Release the planing debris removal port
turning it against the direction of the arrow (out
of the "Lock" position).
Pull the planing debris removal port
the device.
The planing debris removal port
to face left or right in the planer.
Push the planing debris removal port
the device.
Lock the planing debris removal port
turning it into the "Lock" position.
Place the reducer piece
planing debris removal port
Push the hose of a suitable dust extraction device
approved for that purpose (e.g. a workshop
vacuum cleaner) on to the planing debris remov-
al port or the reducer piece
3
Pull the hose of the dust extraction device off
the planing debris removal port
reducer piece .
15
Pull off the reducer piece

Parking shoe (see Figs. B / C)

allows you to lay the device
16
by
3
out of
3
can be set
3
into
3
by
3
when using
15
firmly on to the
15
.
3
.
15
or off the
3
, if fitted.
15
swings up and
16
.
9