Technical Information; General Safety Advice For Electrical Power Tools; Workplace Safety; Electrical Safety - Parkside PBS 900 A1 Originalbetriebsanleitung

1 Dust collection box
1 Extraction adapter
(for external vacuum dust extraction)
1 Fixed mounting kit
1 Operating instructions

Technical information

Q
Belt sander: Parkside PBS 900 A1
Nominal voltage: 230 V ~ 50 Hz
Nom. power input: 900 W
No-load belt speed: 180 - 340 m / min
No-load speed: n
Sanding belt 75 x 533 mm
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Total vibration, EN 60745:
Vibration emission value a
Uncertainty K < 1.5 m / s
WArNING!
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool is
used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actual-
ly in use. This can result in a much lower vibration
Introduction / General safety advice for electrical power tools
345 - 645 min
-1
0
86 dB(A)
100 dB(A)
3 dB
= 2,928 m / s
2
h,D
2
load over the whole of the period of working.
The PBS 900 A1 belt sander has full-wave electron-
ics with additional control electronics, soft start with
inrush current limiting.
General safety advice for
electrical power tools
WArNING! read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice re-
fers to electrical tools powered by mains electricity
(by means of a mains lead) and electrical tools pow-
ered by rechargeable batteries (without a mains lead).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b) Do not work with the device
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
Keep children and other people
c)
away while you are operating
the electrical tool. Distractions
can cause you to lose control of the device.

2. Electrical safety

a) The mains plug on the device must match
the mains socket. The plug must not be
modified in any way. Do not use an
adapter plug with devices fitted with
a protective earth. Unmodified plugs and
matching sockets reduce the risk of electric shock.
GB/IE 7