Product Description; Technical Data En - Abicor Binzel ABIDRIVE CW Betriebsanleitung

TIG cold wire feeder

3 Product Description

Hazards caused by improper use
If improperly used, the device can present risks to persons, animals and material property.
• Use the device according to its designated use only.
• Do not convert or modify the device to enhance its performance without authorisation.
• The device may only be used by qualified personnel (in Germany, see TRBS [Technical Rules for
3.1 Technical Data
1
2
3
Fig. 1
The ABIDRIVE CW is part of a welding system. The wire required for TIG welding is delivered through the
cable assembly (8) and to the manual welding torch (1) .
The wire is fed constantly to the TIG arc via a four-roll drive. The TIG arc is produced by an ABITIG manual
welding torch (1) and an inverter power source (5).
The components required for welding, such as welding current, shielding gas and coolant, are connected to
the ABIDRIVE CW (2) as required. The required welding wire depends on the material to welded and is
taken from the integrated wire spool.
Ambient temperature
Transport and storage
Relative humidity
Tab. 1
Wire feeding unit
Power supply
Wire feeding unit
Power supply
Tab. 2
WARNING
Operating Safety] 1203).
1
LORCH
8
7
Hand-held welding torch
ABIDRIVE CW
ABIDRIVE CW
Power supply
System overview
Ambient conditions
Weight, dimensions
2
6
4 7
Shielding gas cylinder Intermediate cable assembly
5 Inverter power source 8 Cable assembly
6 Coolant recirculator
- 10 °C to + 40°C
- 25 °C to + 55 °C
up to 90 % at 20 °C
approx. 19 kg
approx. 7.5 kg

approx. 580 mm

approx. 185 mm
3 Product Description
3
4
5

280 mm 380 mm

200 mm 175 mm
EN - 5