Replace The Tray 2 And Optional 250-Sheet Tray Pickup; Replace The Tray 2 And Optional 250-Sheet Tray - HP LaserJet 5100 Handbuch

Step 4 Replace the Tray 2 and optional 250-
sheet tray pickup roller
Note Complete this procedure for any optional 250-sheet tray as well.
1
2
3
4
Figure 9 Removing the Tray 2 pickup roller (bottom of the printer)
Hint To reassemble the roller, orient the pin on the roller (item 4) so that it
lines up with the hole in one of the side bushings (item 3). Slide the
cam (item 2) toward the roller until the tab (item 1) snaps into place.
ENWW
Remove the 250-sheet tray.
For Tray 2, carefully tilt the printer on its left side.
-Or-
For an optional 250-sheet tray, set the feeder upside down on the
work surface.
Press the locking tab (Figure 9, item 1) on the white, side cam
(item 2), and slide the cam and the black bushing (item 3) away
from the roller (item 4).
Slide the roller between the two cams, rotate the roller 180
degrees, and then remove the roller from the shaft.
Replace the Tray 2 and optional 250-sheet tray pickup roller
15