Maintenance And Care; Declaration Of Conformity; Noise And Vibration - Felisatti AGF110/1010E Bedienungsanleitung

1.4 Abrasive cloth: for a more rough finish.
2. Gray disks: ideal for finishing jobs (shining) because
they are made with silicon carbide.
2.1 Fine Scotch: for a finer finish.
2.2 Medium Scotch: for a medium finish.
2.3 Mixed: Intermediate finish between medium Scotch
and abrasive cloth.
2.4 Abrasive cloth: for a more rough finish.

MAINTENANCE AND CARE

WARNING! Always unplug the machine before carrying
out work on it.
- Inspect the tool: Using a worn out polishing or polish-
ing tool will reduce working efficiency.
- Inspect the mounting screws: Regularly inspect all
the mounting screws and ensure they are firmly tight-
ened. Should any screw be loose, tighten it immedi-
ately. Failure to do so could put you at serious risk.
- Motor maintenance: Always take the greatest care
over this and make sure that the motor winding is not
damaged and does not become wet with oil or water.
- The vents should always be kept clean and free of
obstacles.
- Clean the machine thoroughly after each use. Blast the
motor regularly with compressed air.
- Check that the mains lead is in good condition. If it is
not, take it to an Official Service Centre to have it
replaced.
- Brush replacement: The brushes should be replaced
after 150 - 200 hours use or when they are less than
10 mm long. Have this done by an Official Service
Centre. We recommend that at every second change
of brushes, you take the machine to one of our Official
Service Centres for general cleaning and oiling.
- Use only Felisatti accessories and spares. Parts the
changing of which is not covered in this instruction
manual, should be replaced in a Felisatti Official
Service Centre (See Warranty/Official Service Centre
address leaflet).
Do not dispose of electric tools in
the household waste!
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.
WARRANTY
See general warranty conditions printed on the attached
sheet.

NOISE AND VIBRATION

This tool has been designed and made to reduce noise
to a minimum. However, in spite of this, in certain
circumstances the maximum noise level in the place
of work could exceed 85 dBA. In this case, the op-
erator should wear ear protection.
The machine's noise and vibration levels, measured in
compliance with EN 60745-1, usually reach:
Acoustic pressure = 90 dB(A)
Sound-power level = 103 dB(A)
Use ear protection!
Vibration acceleration = 2.9 m/s

DECLARATION OF CONFORMITY

We hereby declare, under our sole responsibil-
ity, that the FELISATTI brand products de-
scribed in this manual AGF110/1010E comply
with the following standards or standard docu-
ments: EN60745-1:2008,
EN60745-2-4, EN55014-1:2006+A1, EN55014-
2:1997+A1+A2, EN61000-3-2:2006+A1+A2 and
EN61000-3-3:2008 in accordance with EU
Directives
2004/108/EC and 2002/95/EC.
11
We reserve the right to make technical changes 07/2011
2
EN60745-2-3,
2006/42/EC, 2006/95/EC,
Francisco Ruiz
Plant Mgr.