Mounting Instructions - Linksys WRT 1900AC Benutzerhandbuch

Product Overview
Wall-mounting Placement
The router has wall-mount slots on the bottom of each foot for flexibility in mounting
the router on the wall. The distance between the slots on the short side is 105 mm. The
distance between the slots on the longer side is 2 1 1 mm. Two screws are needed to
mount the router.
Suggested Mounting Hardware
3 mm
6-7 mm 1.5-2 mm
note:
Linksys is not responsible for damages incurred by unsecured wall-mounting
hardware.
WRT 1900AC | Product Overview

mounting instructions

1. Determine where you want to mount the router and which side you should use to
mount it. Make sure that the wall you use is smooth, flat, dry, and sturdy. Make sure
the location is within reach of an electrical outlet.
2. Before drilling holes, choose the template (short side or long side) that fits your
installation. Drill the holes using the correct template.
3. Insert a screw into each hole and leave 4 mm of its head exposed.
4. Position the router so the wall-mount slots line up with the two screws.
5. Place the wall-mount slots over the screws and slide the router down until the
screws fit snugly into the wall-mount slots.
Wall-mounting Template (Short Side)
Print this page at 100% size.
Cut along the dotted line, and place on the wall to ensure precise spacing of holes.
105 mm
3