lamber 045F Bedienungsanleitung Seite 21

First Section - FOR THE USER
WORKING AND USE
The dishwashing machine can wash up to 30 baskets per hour.
The machine protection degree is IP21, therefore it should not be washed with direct high pressure jet water.
The objects to be washed should be correctly arranged for a good washing-up result.
We suggest to descale dishes, from time to time, in order to remove calcareous and/or starchy sediments
by soaking it in suitable solutions suggested by your cleansing agent supplier.
If you need to buy new dishes remember the following: Dishes and cups: preference must be given to
china or non-porous pottery articles, with smooth surface. Glasses: choose a glass suitable to be washed
in dish-washing machines. Surfaces must be smooth and bottoms the least concave possible.
OPERATION BEFORE WASHING
B
EFORE STARTING THE WORKING OPERATION BE
:
SURE THAT
- the cock is open;
- the filters and the overflow are in
their housings;
- the wash arm and the rinse arm are free to
pivot;
- brightener and washing powder dispenser
containers are loaded.
T :
HEN PROCEED
A
-
Open the door and put into the tank,
possibly over the pump filter, about 40 gr. of
non-lathering detergent in power.
Every 10 cycles add about 30 gr. of detergent.
If the machine is provided with an automatic dosing
device, control that the detergent is in its container.
B
-
Place the dishes in the basket minding to
previously remove all solid waste and fat. Do
not overload baskets, dishes must not be placed one
upon the other, water must have the way to run on
each part of the same.
C
-
Turn the machine on by wall switch and
turn the main switch "A" on the control panel
(fig.1 ) into position 1.
At this point the green light "C" will go on and the tank
will fill up with water.
N.B.: If the machine is equipped with a water-
softener with automatic regeneration, each 90
seconds of tank filling duration, the machine stops
for about 2 minutes to carry out the regeneration.
At finish tank loading with water, lamp "D" will
flashing.
D
-
Put the basket into the machine and close
Before cycle starting be sure that light "E" is on This
light indicate that washing water is on the
temperatur
E
-
Choose the washing period cycle between
(1:120 seconds - 2:180 seconds - 3:240 seconds).
Usually 180 seconds .
N.B. On position "1" the first washing cycle of 120
seconds is automatically selected
F
-
Push the button "B".
The green lamp "D" will light up
position),
washing, a 4
seconds with clean water at 85°÷90°C, will start. At
the end of the cycle the lamp "D" will flashing.
Note: The rinse starts only when the temperature of
the water is 85°÷90°C (thermocontrol system).
Bear in mind that the opening of the door interrupts
the cycle and therefore the machine at any moment.
Practically, the opening of the tank works as an
emergency device.
G
-
Take the basket away and repeat the operation
"F".
NOTE. STOP CYCLE function: the washing cycle can
be stopped if you push again the cycle pushbutton "B"
(light "C" flashing now) :
to restarting washing cycl push again button "B".
Manuel self-cleaning cycle:
- Ensure that the tank is empty,
- Make sure that the machine is switched off
- Remove the overflowpipe from the tank
- Close the door of the diswasher
- Press button "A" to switch the machine on
- Self-cleaning cycle starts, you can stop it after 5
minutes,
automatically turn off after 10 minutes. (for Machine
with drain pump the tank fills with water and stops
when maximum level is reached: empty the tank
manually and repeat the operation if needed).
ACHIEVEMENTS
ideal
Any deficiency in the washing process is
apparent when dirty residuals are visible. Any
halos might be caused by an insufficient rinsing:
in this case, check that the rinsing jets are clean
21
ENGLISH
.
and the cycle, including, besides the
seconds stop and the rinsing of 18
otherwise self-cleaning
the door.
(on fix
cycle will