Installation; Mounting The Device - HQ Power VDPLW1440 Bedienungsanleitung

• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.

4. Installation

a) Fixture
• Choose an appropriate mounting location and hang the device on the wall or ceiling using the included brackets.
• Insert the power plug into the mains.
• Switch off the power when not in use.
b) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder at the back of the device.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
c) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
• Push Buttons
There are 4 buttons below the LCD display: MODE, SETUP, UP and DOWN. Normally the LCD will display the
current DMX address of the fixture, like e.g. "DMX Address 001". At this time, press MODE to enter the main
menu. Press UP or DOWN to scroll in the menu or submenu options. Press SETUP again to confirm your
selection.
• Operating modes
Sound-active mode: the unit will react to sound, chasing through the built-in programs.
Auto mode: the unit will automatically chase through the different colours and built-in programs.
Slave mode: the unit will run under slave mode.
DMX512 mode: this function allows you to control each individual fixture with a standard DMX controller.
VDPLW1440
4 HQPOWER