Preparing The Transmitter For The Dive; Mounting The Transmitter On The First Stage - Seac GURU HP Gebrauchsanweisung

PREPARING THE TRANSMITTER FOR THE DIVE

Mounting the Transmitter on the first stage

The Transmitter must be mounted on a High Pressure (HP) port on the regulator first stage.
High pressure ports are usually marked "HP". Check the manual for your regulator to identify the correct port.
Mount the Transmitter using the same method, care, and caution you would employ when mounting a high pressure hose
connected to the pressure gauge. Assemble the Transmitter so that it does not interfere with the regulator hoses.
Always check that the sealing O-ring in the lower (threaded) part of the Transmitter is present, intact, clean, and properly
lubricated. Immediately replace the O-ring whenever it is damaged (HP O-ring: 8.73 x 1.78 NBR 70).
If you do not know how to mount a device on a high pressure (HP) port, contact your instructor!
If the Transmitter is damaged, do NOT mount it on the regulator.
8 English
m WARNING!
This image is only an example. The correct
connection position on your first stage may
differ.