Safety Features; Checking/Reloading Battery Of Canifugue Pro Receiver Collar - Num'axes CANIFUGUE PRO Gebrauchsanleitung

The table below indicates how your collar operates according to the selected mode:
Number of beep sounds heard when
switching modes
1
2
4
5
7
8
• Adjusting the stimulation level of the CANIFUGUE PRO collar
To change the stimulation level, proceed in the following way:
− When switching on the collar, keep the magnetic key in contact with the area where the magnetic switch is located on the front of the collar (ref.
Diagram 5).
After the 2 beep sounds indicating that the collar is on, a series of beep sounds is emitted (from 1 to 8) indicating the selected mode.
Modes 1 to 8 run through as long as you leave the magnetic key in contact with the area where the magnetic switch is located on the front of the collar.
− Move the magnetic key away from the collar as soon as you have reached the desired mode.
The collar will memorize your selected mode.
Next time you will switch on the collar, it will be in the mode you selected last.
• Adjusting the stimulation level of the CANIFUGUE MIX collar
To change the stimulation level, proceed in the following way:
− To change the mode, the collar must be switched on (battery in its housing).
− Open the battery cover in order to get access to the adjustment button (ref. Diagram 6).
− Press the button using a pointed object (e.g. screwdriver).
A series of beep sounds is emitted (from 1 to 8) indicating the selected mode.
Modes 1 to 8 run through as long as you as long as you keep pressing the button.
− Release the button as soon as you have reached the desired mode.
The collar will memorize your selected mode.
Next time you will switch on the collar, it will be in the mode you selected last.

Safety features

•
The CANIFUGUE PRO/CANIFUGUE MIX pet fencing system comes complete with 3 safety features:
• wire break alarm
If the antenna wire breaks or if a connection fails, the transmitter will alert you to this operating default:
− the transmitter will emit continuous beep sounds
− the LCD screen will flash
− a symbol will flash on the screen (ref. Diagram 3)
• warning zone evacuation feature
After 10 seconds approx. (CANIFUGUE PRO) / 20 seconds approx. (CANIFUGUE MIX) of continuous presence in the warning zone, your dog will be
signalled to leave the zone by the emission of a few short stimulations (stimulation level depending on the selected mode).
• stimulation zone evacuation feature
If your dog remains in the stimulation zone for approximately 20 seconds, the CANIFUGUE PRO/CANIFUGUE MIX collar stops emitting stimulations. The
normal functioning resumes when your dog leaves this zone.
•

Checking/reloading battery of CANIFUGUE PRO receiver collar

To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
− battery sufficiently charged: flashes green every 5 seconds
− weak battery:
− When the collar is On: flashes green 5 times every 5 seconds
− When switching On the collar: flashes green 5 times and the collar emits 5 beep sounds then the indicator light flashes 5 times every 5 seconds
− When switching Off the collar: the indicator flashes green 5 times and the collar emits 5 beep sounds then goes out
When the battery is too weak, the product switches to safety mode and the system locks up.
Recharge the battery by following the procedure indicated above (see § Charge of the CANIFUGUE PRO collar).
Due to greater use during your dog's training, the first charges of the collar may not last as long as the following ones. Battery life depends on how
often your dog tests the boundary.
Mode Stimulation level
1
low stimulation levels:
2
for small dogs or dogs with sensitive temperament
3 3
4
medium stimulation levels:
5
for medium dogs or dogs with average temperament
6 6
7 strong stimulation levels:
8 for large dogs or dogs with difficult temperament
Gb - 22