Mx Onda MX-AS2060 Benutzerhandbuch Seite 46

b. Close the lower lid of the dustbin, a "click" will indicate that it is properly
closed.
c. Insert the particulate filter inside the cabin at the top of the udstbin so
that the rubber ring particulate filter properly fit over the edge of the
multi-cyclone filter, then press lightly with your fingers on the rubber
ring to check that it is fully assembled. Finally, close the lid and a "click"
will indicate that the cover is securely closed (Fig. 10).
d. Attach the dustbin (fully assembled) at the bottom of the main body of
the vacuum cleaner, and then push the dustbin into the vacuum, when
you hear a "click" is an indication that the dustbin is properly attached
to the main body of the vacuum cleaner (fig. 11).
Fig. 9
Cleaning the HEPA filter (post motor)
The HEPA filter post motor is located in the rear of the vacuum cleaner. HEPA
filter cleaning should be performed at least every 6 months for cleaning
proceed as follows:
•
Press down on the tabs to open the post cover
HEPA filter engine and pull it out.
•
Remove the HEPA filter and wash with water,
then let it dry by itself. Do not dry with a hair
dryer or heater.
•
With the filter clean, dry place in
compartment and replace the cover into place,
making a slight pressure on it, a "click" will
indicate that it is properly attached.
Warning: Never connect the vacuum cleaner to the mains supply without
being properly positioned in place all filters.
Fig. 10
its
10
Fig. 11