Closing The Door; Noises - AEG ABB66011AS Benutzerinformation

Problem
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

8.2 Closing the door

1. Clean the door gaskets.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
Possible cause
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
The "FROSTMATIC func-
tion" is switched on.
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Set a higher temperature. Re-
fer to "Operation".
Set a higher temperature. Re-
fer to "Operation"
Refer to "Operation" .
The compressor starts after a
period of time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FROSTMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.
27