Configuration - elobau 485EPF series Originalbetriebsanleitung

CONFIGURATION

Once the module is connected it is recognized and you can configure the parameters by selecting the
different cards shown in figures 9 to 12 (CONFIG key – figure 7; press the WRITE-button to send the
configuration data to the module.
Figure 9 - I/O selection
Figure 11 - Baud rate
eloProg 485EPF.. - Vers. 1.2
485EPB
Status
ADDRESS
485 EPB
Status
485EPFCO
485EPFDN
485EPFPD
485EPFEC
485EPFEI
485EPFPN
Figure 10 - Address
BAUD
RATE
Input status
Field bus input status
127 AUTO
Probe status
Output status
Input status
Input status;
63 AUTO
Probe status
Output status
Input status
Field bus input status
126 N/A
Probe status
Output status
Input status
Field bus input status
0 N/A
Probe status
Output status
Input status
Field bus input status
0.0.0.0 AUTO
Probe status
Output status.
Input status
Field bus input status
0.0.0.0 N/A
Probe status
Output status
Table 14 - Default values
485 EPB
Status
INFORMATION SETS
16