Initial Operation - Jasneva Vlahova SB3212 Gebrauchsanweisung

Initial operation

 Open the battery compartment cover
 Insert AAA size LR03*3PCS batteries observing polarity ["+" and " –" marks]
 Inserting the connecting line DC plug into the power socket, insert the USB plug at the other end into the
charger's socket.
Clock settings
 Press the button
 Press and hold the button
the 12HR or 24HR timing format you need.
 Press
button to confirm your setting, the HOUR display starts to flash. Now use "+" and "-" buttons to
set the correct HOUR.
 Press
button to confirm your setting, the MINUTE display starts to flash. Now use "+" and "-" buttons to
set the correct MINUTE.
 Press button to confirm your setting, the °C/°F display starts to flash. Now use "+" and "-" buttons to
set °C or °F unit you need.
 Press
button to confirm your setting and to end the settings procedures, then return to the clock mode.
 When choosing the 12HR format and set the HOUR, if the minute position display
hour is A.M.(ante meridiem), if the minute position display
------hour is A.M. 6
------hour is P.M. 2
F.Y.I.:
 If there is no valid operation within 15 seconds, it will automatically return to normal time mode from the set
mode.
Daily alarm settings
 Press 【+】 button, you can set Alarm1 and Alarm2 ON or OFF, symbol
ON, symbol appear means that ALARM2 is ON, symbol
ALARM is OFF.
 Press
button the time will switch to ALARM1 time display, press again, ALARM2 time is display on the
screen.
 Press and hold
buttons to set the required hours.
 Press button to confirm your setting, The Minutes of the Alarm1 time starts to flash. Use the "+" and "-"
buttons to set the required minutes.
 The setting item in order is:
Alarm1 HOUR → Alarm1 MINUTE → Alarm2 HOUR → Alarm2 MINUTE
 Press
button to confirm your setting and to end the setting procedure.
 The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the alarm
will be repeated automatically after 24 hours.
SB3212 User Manual
to switch to display ambient temperature 5 seconds.
for 2 seconds, the 12/24HR start to flash. Now use "+" and "-" buttons to set
button for 2 seconds, the hours of the ALARM1 time starts to flash, Use the "+" and "-"
, it means that the hour is P.M.(post meridiem).
appear means that ALARM1 is
or disappear means that Corresponding
(EN)
, it means that the