After Use - Braun Satin Hair Styler EC 2 Handbuch

Styling
Preparing for use
• Make sure your hair is completely dry before using the appliance.
• Comb your hair with a wide-toothed comb to remove tangles.
• Section your hair off. Starting at the hair tips, clamp a section of
hair (strand of 3-4 cm max.) with the tong.
Creating curls and waves
• Gently wind the strand up to the roots. Allow the strand to remain
curled up for a couple of seconds before unwinding it. For best
results, slightly press the tong opener [4] in order to smoothly
release the strand. For better handling, you may hold the cool
tip [1] with your other hand.
• You can even straighten a strand that already has been curled
by clamping the strand at the roots again and then letting the
appliance glide slowly and carefully along the strand towards the
hair tips.
• For safety reasons, the appliance will automatically turn off after
approximately 30 minutes.
• Simply press the on/off button [7] again in case you may want to
continue using the appliance.

After use

• After each use, switch off the appliance by pushing the on/off
button [7] for one second.
• Keep in mind that the heating barrel is still hot. Do not touch it to
avoid any risk of burns. After 20 minutes cooling time, you will be
able to touch the heating barrel without any risk.
• During use and cooling down, the appliance always has to be
placed on a heat-resistant surface.
Cleaning
• Always unplug before cleaning. Never immerse the appliance in
water.
• Clean the appliance with a damp cloth and use a soft cloth to
dry.
Subject to change without notice.
This product conforms to the European Directives EMC
2004/108/EC and Low Voltage 2006/95/EC.
Please do not dispose of the product in the household
waste at the end of its useful life. Disposal can take place
at a Braun Service Centre or at appropriate collection
points provided in your country.
Downloaded from www.vandenborre.be
7