Rimage 2000i Series II Handbuch Seite 23

Maintain the Rimage 2000i Series II
5. Open the ink cartridge access door.
6. Align the printer from side to side.
Note: If the printer must be aligned front to back, continue to step 7.
Allen
Torx
a. Loosen the Torx T25 screws (Qty. 2) at the front of the printer until
you can move the printer from side to side.
b. Gently grasp the small metal tabs (Qty. 2) on the printer.
Metal Tabs
2002760_A
Ink Cartridge
Access Door
Torx
For more information visit
c. Move the printer to the left or right as needed.
d. Repeat step 3 to check the printer alignment.
e. If necessary, repeat step b - step d until the printer is properly
aligned from side to side.
f. When the printer is properly aligned, tighten the Torx T25 screws
(Qty. 2) to ensure continued alignment.
7. Align the printer from front to back.
a. Using a 5/32" Allen wrench, turn the center front 5/32" Allen screw
(Qty. 1).
• Turn the Allen screw clockwise to move the printer toward the
front of the Rimage 2000i.
• Turn the Allen screw counterclockwise to move the printer
toward the back of the Rimage 2000i.
b. Repeat step 3 to check the printer alignment.
c. If necessary, repeat step 7 until the printer is properly aligned from
front to back.
8. Remove the disc from the printer tray.
9. Press . The printer tray closes.
10. Close the ink cartridge access door.
11. Press and hold the operator button until [EXIT TEST MODE DIAGNOSTIC]
displays on the operator panel.
12. When [EXIT TEST MODE DIAGNOSTIC] displays on the operator panel,
release the operator button.
Note: If [PAUSE...] displays on the operator panel, press and release the
operator button. [RIMAGE 2000i READY] displays on the operator panel.
The Rimage 2000i is ready for use.
rimage.com/support
20