Safety Information; Troubleshooting - Enerpac FL2101 Bedienungsanleitung

SAFETY INFORMATION

To avoid personal injury during system operation, read and follow all
CAUTIONS, WARNINGS, and INSTRUCTIONS included with or attached to
each product. ENERPAC CANNOT BE RESPONSIBLE FOR DAMAGE
RESULTING FROM UNSAFE USE OF PRODUCT, LACK OF MAINTENANCE, OR
INCORRECT PRODUCT OR SYSTEM APPLICATION. Contact Enerpac when in
doubt about applications and safety precautions.
equipment damage can occur if system operating pressure exceeds the maximum
pressure rating of system components.
corrosive chemicals. DO NOT expose hydraulic equipment to temperatures above
150°F (65°C).
PLACEMENT OF FILTERS
Filters should be placed on the pallet-side of the fixture coupling point. Filters
should always be used between the fixture coupling point and any valving. (See
Figures 1 and 2.) When attaching the FL2101 and FL2201 series filters directly into
a #4 SAE port, use connector fitting FZ-2005. When attaching the FL2102 and
FL2202 series filters directly into a
COMMON APPLICATIONS
FL2201 and FL2202 (20 micron filters)
The FL2201 and FL2202 should be used with the following applications: the
accumulator shut-off block, the auto coupler receiver block, and any hydraulic
system utilizing a palletized disconnect system. (See Figures 1 and 2.)
FL2101 and FL2102 (10 micron filters)
The FL2101 and FL2102 should be used with PIN/PID intensifiers (see Figure 3)
and with the CRV series of rotary couplers.

TROUBLESHOOTING

If your hydraulic system exhibits signs of poor performance, such as sluggish or erratic
movements, the filters may need to be cleaned or replaced. Refer to Enerpac Repair
Parts Sheet L2222.
WARNING
The system operating pressure must not exceed the maximum pressure
rating of the lowest rated component in the system. Personal injury and/or
WARNING
Make sure that all system components are protected from external
sources of damage, such as flame, moving machine parts, sharp objects,
(2)
1
⁄ BSPP port, use connector fitting BFZ-2045.
4