Certificate: 80003373
Project: 80003373
CONDITIONS OF ACCEPTABILITY
(1)
If at any time there is a conflict between the system safety provisions and any relevant local (national or
regional) requirements, the local requirements always take precedence.
(2)
For use in dry locations and indoor only.
(3)
No user replaceable battery. Internal non rechargeable lithium cell can only be replaced by Service
personnel.
(4)
Appliance coupler on power cord is considered as a disconnect device, it must remain accessible.
(5)
Professional laboratory equipment; only trained personal is allowed to operate the unit.
(6)
Pump is only allowed to be operated once the tubing has been properly installed into the unit.
APPLICABLE REQUIREMENTS
CAN/CSA-C22.2 No. 61010-1-12
+ UPD1:15 + UPD2:16 + AMD1:2018
ANSI/UL 61010-1-2012 +AMD1:2018
DQD 507 Rev. 2019-04-30
-
Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use, Part 1: General Requirements
-
Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use - Part 1: General Requirements
© 2018 CSA Group. All rights reserved.
Master Contract: 167555
Date Issued: 2019-07-24
Page 2