Protection Against Overheating; Storage; Troubleshooting; Causes Of Malfunction And Fault Rectification - Silvercrest SLE 320 C4 Bedienungsanleitung

Protection against overheating

The appliance has an overheating protection. It switches off automatically if
there is a risk of overheating and switches back on once the appliance has fully
cooled down. The appliance cannot be used during the cool-down phase.
♦ Check whether external conditions may have triggered the overheating
protection (e.g. temperatures above 35°C or a closed air outlet flap

Storage

♦ Remove the plug from the mains power socket. Roll up the mains cable
loosely and wrap the Velcro around it so that it does not become a tripping
hazard.
♦ Empty the water tank
long time.
♦ Always store the appliance in an upright position and in a dry and dust-free
environment without direct sunlight.

Troubleshooting

This section contains important information on fault identification and rectification.
Causes of malfunction and fault rectification
The following table will help you to identify and rectify minor malfunctions:
Fault Possible cause
The plug is not plugged in.
The mains power socket is not
The appliance
supplying power.
will not switch
on.
Safety stop due to missing or
incorrectly inserted water tank
The water tank
The automatic defrosting function
The appliance
is activated.
stops occasion-
ally (the fan
The humidity of the room has
switches off).
reached the desired level.
The air inlet or air outlet openings
is contaminated or obstructed.
The appliance
is producing The room's windows and doors
no or too little are open.
condensate.
The appliance is running in the
AIR CLEAN programme.
Dehumidification is not taking place.
■ 20 │ GB │ IE │ NI
if you are not going to use the appliance for a
Remedy
Insert the plug into the mains power
socket.
Check the house mains fuse.
Insert the water tank
.
is full. Empty the water tank
This is a normal feature of the
appliance.
This is a normal feature of the
appliance.
Ensure that the air inlet and air
outlet opening are clean and
free of obstructions.
Close the windows and doors.
Select another programme, such
as TARGET HUMIDITY.
).
correctly.
and reinsert it.
SLE 320 C4