Parallel Interface; Specifications; Input And Output Signals; Electrical Characteristics - Citizen CBM-292 Bedienungsanleitung

7. PARALLEL INTERFACE

7.1 Specifications

Data input system
Control signals

7.2 Input and Output Signals

• DATA0 ∼ 7
• STROBE
• RESET
• ACK
• BUSY
• FAULT
• PE

7.3 Electrical Characteristics

(1) Input signal levels
"HIGH" level
"LOW" level
(2) Output signal levels
"HIGH" level
"LOW" level
(3) Input/output conditions
The STROBE and RESET input signals are all pulled up at 3.3kΩ.
[Printer Side]
All the output signals are pulled up at 50kΩ.
: 8-bit parallel system(DATA0 ∼ 7)
: ACK, BUSY, STROBE, FAULT, PE, RESET
: An 8-bit parallel signal.(Positive logic)
: A strobe signal to read the 8-bit data.(Negative logic)
: A signal to reset the entire control board.(Negative logic)
: An 8-bit data request signal.
A pulse signal to be output at the end of the BUSY signal.(Negative logic)
: A signal to indicate the BUSY status. Input new data when "LOW."
(Positive logic)
: A signal turned to "LOW" in case of the alarm status.(Negative logic)
: A signal to be output when the printing paper runs out.(Positive logic)
: 0.7Vcc at minimum
: 0.3Vcc at maximum
: Vcc-0.1V at minimum
: 0.1V at maximum
[Host Side]
32
CBM-292/293 User's Manual
The others are pulled up at 50kΩ.
CITIZEN