Electrical Characteristics; Preparing The Appliance - SOLAC CP7320 Gebrauchsanleitung

CP 7320.book Page 14 Wednesday, December 19, 2007 11:51 AM
6 Cutting blades
7 Comb guide fastening tabs
8 Charge connector
9 Charge pilot light
10 Charger
11 Guide combs for normal cut (2 mm, 4 mm, 6 mm, 8 mm)
12 Guide comb for 2-mm combined cut
13 Guide comb for 0-mm cut
14 Guide combs for the ear area (side guide combs)
15 Guide comb for thinning very thick hair (reduction comb)
16 Comb
17 Cleaning brush
18 Lubricating oil

Electrical characteristics

Charger power supply voltage: 230 V, 50 Hz
Ergonomic design
The advanced design of this appliance allows a person to comfortably
cut his own hair around his whole head, even in difficult areas such as
the nape of the neck or the sides of the head. To do so, it has an
adjustable handle (Fig. 1) and an adjustable head (Fig. 2) so that you
never have to force your wrist.
In addition, with the charger disconnected, it can be used in places
where there is water, such as the shower.

3 Preparing the appliance

Recharging the batteries

The hair clipper includes batteries for operating without the power cord.
Whenever the batteries are discharged, they must be charged using the
supplied charger (10).

Any repairs or battery replacements should be performed by an
Authorised Technical Service.

Use only the supplied charger. Do not use any other.
1 Place the switch (2) in the "0" position.
2 Connect the charger cable to the appliance's connector (8)
3 Plug the charger into the mains. The charge pilot light (9) will light up red.
4 The charge time is approximately 12 hours. The charge pilot light (9) will
light up green when it is fully charged.
14 Preparing the appliance