Fermax VEO WIFI DUOX Installationshandbuch Seite 46

Notes:
- The period between the monitor programming entry confirmation beep and the call
from the panel to program the monitor address must be less than 2 and a half minutes.
- The panel from which the programming takes place must be designated as the
master panel.
A different ring tone is produced, confirming the programming of the monitor, and the
camera image continues to be displayed. After
the rest position.
by a continually lit red LED.
C) From the Doorbell.
The monitor address can also be programmed
For this type of operation, the monitor must not be previously programmed.
Press and hold the doorbell for 5 seconds, and you will hear a beep confirming access to
the monitor's programming mode.
The monitor is automatically connected to the outdoor panel by activating the camera.
Enter the calling code for that monitor from the panel, depending on the type of panel
installed:
• By pressing the corresponding button.
• By entering the code + bell.
A different ring tone is produced, confirming the programming of the monitor, and the
camera image continues to be displayed. After
the rest position.
by a continually lit red LED.
Notes:
- The period between the monitor programming entry confirmation beep and the call
from the panel to program the monitor address must be less than 2 and a half
minutes.
- The panel from which the programming takes place must be designated as the
master panel.
14
DUOX WIFI VEO MONITOR
Once the monitor address has been programmed, this will be indicated
Once the monitor address has been programmed, this will be indicated
a few seconds, the monitor will return to
-
via the entrance doorbell .
a few seconds, the monitor will return to