gopart FGP455236GP Handbuch Seite 10

5. (Figure 13) Place the assembled lower hopper tubes into the bottom of the hopper bag.
6. (Figure 13) Attach the ends of the lower hopper side tubes to the inside of the upper side tubes using two Ø9.5X25
clevis pins inserted from the inside, and two hair cotter pins Ø3.
UK
Ø 3 HAIR
COTTER PIN
HOPPER BAG
BOTTOM
7. (Figure 14) Insert the bag frame strap into the stitched sleeve along the front edge of the bag bottom.
8. (Figure 14) Assemble the bag frame strap to the lower hopper side tubes using two Ø6X37 clevis pins and two hair
cotter pins Ø2.
9. (Figure 15) Secure the bag corners around the lower hopper side tubes by snapping the bag flaps to the bag bottom on
both sides.
IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the steel rods to loose
supporting tension.
10
13
UPPER HOPPER
SIDE TUBE
Ø 9.5X25
CLEVIS PIN
LOWER HOPPER
SIDE TUBE
BAG FRAME
Ø2 HAIR
STRAP
COTTER PIN
Ø6X37
CLEVIS PIN
15
Flap
14