Bosch WBE 4110 Bedienungsanleitung Seite 20

en 20 | WBE 4110 | How to use the machine and surfi ng menu
3.2 Configuration of the board
Press "SET" until the notice "TOL " is shown and then
press "MM/INCH".
Left Display Right Display Description
POT OFF/ON
3.3 Self-calibration
Press "SET" until the notice "CAL " is shown and then
press "MM/INCH".
Left Display Right Display Description
C-1
Left Display Right Display Description
D-1 0 or higher
Left Display Right Display Description
D-2 200
Left Display Right Display Description
H-1 ex.: 14"
Left Display Right Display Description
C-2
C-3
C-4
C-5
3.4 Auto-diagnosis
Press "SET" until the notice "TST" is shown and then
"MM/INCH".
Left Display Right Display Description
Msr
ex.: 384
Ex.: 603
ex.: 179 Ex.: 580
Ex.: 2
Left Display Right Display Description
Enc
Left Display Right Display Description
SP
Left Display Right Display Description
A0 510
|
1 695 654 756 2008-10-17
It turns on and off the in-
ternal automatic gauge
Memorization of the flange
zero group and shaft
Calibration of the distance
potentiometer: position of rest
Calibration of the distance
potentiometer: position at 20cm
Calibration of the diam-
eter potentiometer
Setting up of the wheel size and
memorization of the unbalance
Setting up of the calibration weight
and launch with the weight inside
Launch with the weight outside
Adjustment of the angle
Press "+" DISTANCE to
roll down menu
1° shown value:
measured tension left pick-up
2° shown value: meas-
ured tension right pick-up
3° shown value: phase an-
gle difference
4° value: Ratio between the
rounded off pick-ups
It shows the position of the
encoder from 0 to 255
Speed in turn/min of the shaft
Reading analog en-
try of the right pick-up
A1 510
A2 510
A3 510
A4 ###
A5 200
A6 ###
A7 200
Left Display Right Display Description
INP ON/OFF
Left Display Right Display Description
Cnt
1 500
6
Left Display Right Display Description
Led
Left Display Right Display Description
Tar
Left Display Right Display Description
Rel off
!
NOTE: All the options are described in details on the
following pages.
Press "+" DISTANCE to
roll down the menu
Reading analog en-
try of the left pick-up
Reading analog entry of the
enlarged right pick-up
Reading analog entry of the
enlarged left pick-up
NON USED
Reading distance potentiometer
NON USED
Reading diameter potentiometer
Position of the carter: OFF open,
ON lowered
Press "+" DISTANCE to
roll down the menu
Overall launches ex:1500
Daily launches, since when the bal-
ancing machine has been turned on
Press "+" DISTANCE to
roll down the menu
Press "+" DISTANCE to
roll down the menu
Start of the respective bal-
ancing procedure
Robert Bosch GmbH