Connecting The Ac Adapter - Audio-Technica AT-LPW40WN Bedienungsanleitung

Preparation for use
Installing/removing the dust cover
When attaching the dust cover, insert the hinges of the dust cover
into the two dust cover hinge holders on the back of the body. When
removing the dust cover, slowly pull the dust cover out from the dust
cover hinge holders.
Setting output selector switch
This product has a built-in phono equalizer function. You can use the
product, even if you do not have a phono amplifier or connectable
equipment with a built-in phono amplifier, by connecting an active
speaker, etc.
Use the output selector switch to set the output, as shown below.
Connectable Position of
equipment being output selector
used switch
Device with phono PHONO
input
Device without LINE
phono input
PC sound card LINE
* An audio adapter (sold separately) may be required to connect the
RCA audio cable to the PC sound card's line input jack.
Connecting to connectable equipment (active
speakers, amplifiers, etc.)
Align the settings for the output selector switch and connect the RCA
audio cable to an input jack that is compatible with the connectable
equipment you are using (amplifier, receiver, active speakers, sound
card, etc.).
7
Where to connect the
RCA audio cable
Phono input jack and
ground (earth) terminal of
connectable equipment
AUX or line input jack of
connectable equipment
Sound card's line input
jack*
• The RCA audio cable's red jack is for the right (R) channel, and the
white jack is for the left (L) channel.
With PHONO input*
Connectable
equipment
(amplifier, etc.)
With PHONO input*
* Depending on the equipment you are connecting, a ground (earth)
terminal may exist near the phono input jack. If this is the case,
connect to it using the ground line from the RCA audio cable. This
will help prevent a low humming noise that might otherwise be heard
during playback.

Connecting the AC adapter

This product does not have a power switch. A standby current is
always running through the product, even when it is not being used;
disconnect the AC adapter from the outlet when not using the product
for a long period of time.
1. Connect the AC adapter's cord to the AC inlet.
2. Plug the AC adapter into an outlet.
• Make sure that the control knob is in the "STOP" position.
• If you play a record immediately after plugging the AC adapter into an
outlet, the sound that is played may be garbled. Wait a short time (about
30 seconds) after plugging the AC adapter into the outlet before playing a
record.
Without PHONO input
To outlet
To outlet
Without PHONO input