Settings; List Of Parameters; Setting The Parameters; Selecting The Operating Mode - De Dietrich KALIKO Essentiel ETWH180E Installations- Und Wartungsanleitung

9

Settings

9.1

List of parameters

Tab.37 Parameters available in the operating modes
Parameter
:
:
:
:
9.2

Setting the parameters

Fig.125
Fig.126
Fig.127
Fig.128
7659610 - v02 - 08032017
The following parameters can be accessed in all operating modes: ECON­
OMY MODE / HYBRID MODE / OPT.BACKUP
Description
Water temperature difference between the set point and the
restart.
Can be set from 3 to 20°C.
Room temperature limit authorised for operation of the heat
pump.
Room temperature operating limit for the electrical back-up.
Can be set from 5 to 18°C
Main timer range duration at Off-peak rate if cabled
9.2.1
9.2.2
The adjustable parameters are as follows, regardless of the selected oper­
ating mode
MODE
9.2.3
Switch off the power supply by pushing the circuit breaker down to the
OFF position.

Selecting the operating mode

1. Unlock the control panel by pressing the CANCEL key for 3 sec­
onds.
The locking indicator goes out.
2. Select the required mode by pressing the MODE key.
3. Confirm the required operating mode by waiting 10 seconds.

Setting the various parameters

1. Access the setting parameters by pressing the two keys opposite si­
multaneously.
2. Adjust the value for the parameter
site.
3. Adjust the parameter
4. Adjust the parameter

Configuring the anti-legionella function

9 Settings
Factory setting
5°C
5°C
10°C
8 hours
by pressing the keys oppo­
by pressing the keys opposite.
by pressing the keys opposite.
en
217