Screen Messages - ZUMEX Essential Basic Bedienungsanleitung

Fault Possible cause
The faucet gets blocked The juice has seeds or too much
pulp.
The machine stops every Insufficient ventilation.
now and again
Overload.
Screen does not display Alteration to mains systems.
information
The machine is in self- Faucet not fitted or fitted
service mode and won't incorrectly.
stop operating
Faucet well fitted: possible
internal fault.
Faucet block activated.
Warning: Any action to unblock the machine must be carried out by disconnecting it
from the mains. If, after making the checks stated here, the machine does not work,
call the technical service.
Correction
Disassemble and clean the
faucet according Fig. 11A.
Check that the appliance's
ventilation grilles are not
blocked.
Contact your technical service.
Turn off the machine and turn it
back on again.
Fit the faucet in the manner
indicated in Fig. 11A
Contact your technical service.
Put the block in horizontal
position by pressing the faucet
downwards.

Screen Messages

Display Message Cause
Excess current The maximum electrical
consumption level has been
exceeded for at least one
second.
No oranges The motor remains on for
two minutes detecting any
squeezing.
Memory initiated A memory error has been
detected.
Calibration An incorrect calibration value
has been detected.
Out of service The counter has reached zero.
Eeprom Error detected in EEPROM
memory.
Out of range The input power voltage is
less than 80V or greater than
260V.
Keyboard error (error 1) No communication with the
keyboard (Internal fault).
Juice tray picture flashing Check the juice tray and front
cover are placed correctly.
*The message: "Keyboard error" may not appear on the display as there is no communication between the
CPU and the keyboard panel
EN
Correction
Turn off at mains and turn
back on again.
Put oranges back in feeder
again without and press ON.
Contact your technical service.
Calibrate (See page 20).
Modify the discounter value as
indicated in page 21 or move
on to counter function entering
PARTIAL COUNTER and
pressing ON.
Contact your technical service.
Contact your technical service.
Contact your technical service.
Place the tray and cover in its
correct position as Fig. 4. If the
picture does not disappear,
contact your technical service.
33