Installation - Velleman components MA620B Bedienungsanleitung

REMOTE CONTROL MOTORCYCLE ALARM SYSTEM
This alarm system will provide years of dependable operation. Yet, quality and longevity of
the system is determined by the installation. For information on operating the system, read the
operation manual.
IMPORTANT POINTS FOR ALARM INSTALLATION
ALWAYS : Install the alarm on dry, keep away from grease, dirt engine and exhaust parts.
ALWAYS : Disconnect the motorcycle battery before connecting work on the motorcycle.
ALWAYS : Check behind panels before drilling holes. Ensure no wires or components
behind panels.
ALWAYS : Use conventional crimp lock, bullet on any wiring.
IMPORTANT : Suggest soldering all connection point, if the wire's current is more than 10
Amps.
This alarm designs to keep installation as simple as possible. However, if problems, please
ask advice of a skill person. If someone not familiar with motorcycle electrical installation,
we strongly advise seek qualified advice before proceeding.
Before connecting with the wiring of the motorcycle, read the instruction carefully.
***************************************************************************
TOOLS REQUIRED :
***************************************************************************
GENERAL SPECIFICATIONS :
Power Requirements
Fuse Ratings - Red Power wire -
- White Parking Flash wire -
Current Consumption
Arming Delay
Alarm Timer
Triggers inputs
Receiver channel
Learning limitations
A. MOUNTING THE SIREN
1. Place the siren in a location suitable for best sound result.
Note : Preferred siren position is facing forward or straight down to the ground. Siren should
not be face up.
2. Make and drill two holes to mount the siren.
MA620B
OPERATING MANUAL MA620'B
INTRODUCTION
• Wire Crimper
• Wire Stripper
• Pliers
• Voltmeter

INSTALLATION

3
• Electric Drill & Bits
• Socket Set
• Cross Screwdriver
• Electronic Tape
+ 12 Volts & Negative Ground
3 Amps
10 Amps
Less than 5mA Stand By
3 seconds
30 seconds
Ignition switch sensing
Trigger for optional sensor
Shock sensor
3 Channels
2 Transmitters
VELLEMAN