Connection - SolarEdge Immersion Heater Controller Installationshandbuch

Connection

Connect the Immersion Heater Controller through a circuit breaker in the AC distribution panel. Use a 3-
core cable with a minimum wire cross section of 2.5 mm
diameter (6 - 12 mm or 4 - 8mm).
Refer to Figure 4.
1. Insert the AC cable coming from the mains through the gland.
2. Insert the wire coming from the mains and going to L (line) through the current transformer (CT) .
Make sure the arrow inside the CT (and green dot) is pointing towards the mains.
3. Connect the wires to the terminal blocks according to the labels.
4. Insert the cable from the immersion heater through the gland and connect the wires according to
labels on the terminal block .
SolarEdge-Immersion Heater Controller Installation Guide MAN-01-00279-1.3
Figure 4: Immersion Heater Controller connections
Immersion Heater Controller Installation Guide
2
. Use the connection gland suitable for the cable
5