Model Identification; Operating Instructions; Hitching The Mower; Setting Cut Height - GOLDONI TP60 Bedienung Und Instandhaltung

2. MODEL IDENTIFICATION

Model identification data are punched on the rotation stop reinforcement (n.7
fig.1)

3. OPERATING INSTRUCTIONS

3.1 HITCHING THE MOWER

The engine must be stopped. Push the mower sleeve into the tractor's quick
couple n.8 fig.1.
Place spacers n.6 fig.1 over and under the wheel pin, depending on the type of
wheels mounted on the tractor, so that the mower is horizontal.
Admissible wheels are from 3.50x8" to 4.0x10" (max. outside diam. is 430 mm).
Before starting the engine, check to make sure the PTO is in neutral. First
engage the PTO and the forward gear.
⇒
Drive direction

3.2 SETTING CUT HEIGHT

Four cut heights can be set with lever 1 fig.1.
MIN - Leva forward: minimum cut height.
MAX - Leva back: maximum cut height.

4. MAINTENANCE - CLEANING - LUBRIFICATION

4.1 CHECKING AND ADDING OIL

After every 50 work hours check the oil level and top up as needed through filler
plug 2 fig. 1. The level of the oil must be 50 mm below the top of the hole.
After every 200 work hours drain the oil from filler plug 2 (fig.1) by turning the
attachment upside down.
It is advisable to use AGIP ROTRA MP SAE 80W/90 oil. Quantity required is
about 0,4 liter.
Comply with the following specifications if other lubricant makes are used:
Agip Rotra MP SAE 80W/90 oil
Viscosity at 40° C (mm2/s)..............144
Viscosity to 100° C (mm2/s)..............15
Viscosity at -26° C (mPa.s) .......110000
Viscosity index ................................104
Flash point V.A. (°C) .......................210
Pour point (°C) ................................ -27
Absolute gravity at 15 °C (Kg/l) ....0.900
15