Truck Requirements - Cascade 798063-R5 Benutzerhandbuch

TRUCK REQUIREMENTS

WARNING: Rated capacity of the truck/forks
combination is a responsibility of the original truck
manufacturer and may be less than that shown on the
attachment nameplate. Consult the truck nameplate.
Truck Relief Setting
Pressure
2000 psi (137 bar) - Recommended
2300 psi (160 bar) - Maximum
Truck Flow Volume
18C thru 105C
➀ Cascade Telescopic Forks are compatible with SAE 10W
petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or
MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid
is not recommended. If fire resistant hydraulic fluid is required,
special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in reduced system
performance.
➂
Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
Carriage Mount Dimension (A) ITA (ISO)
A
Class II
Class III 18.74 in. (476.0 mm)
Class IV 23.44 in. (595.5 mm)
Auxiliary Valve Functions
Check for compliance with ANSI/ITSDF (ISO) standards:
5
(see nameplate)
➀
Recommended
➁
Min.
4 GPM 6 GPM
(15 L/min.) (23 L/min.)
Minimum
14.94 in. (380.0 mm) 15.00 in. (381.0 mm)
18.74 in. (476.0 mm)
23.50 in. (597.0 mm)
FK0530.eps
➂
Max.
8 GPM
(30 L/min.)
Maximum
Tilt
Forward
Hoist Down
Hoist Up Tilt
Back
Carriage
Clean carriage bars and inspect
carriage bars. Make sure the bars are
parallel and that ends are flush. Repair
any damaged notches.
Fork Extend
Fork Retract
798063-R5 EN
GA0390.eps