Maintenance / Cleaning - Silvercrest EDS SBB 850 B1 Bedienungs- Und Sicherheitshinweise

SilverCrest EDS SBB 850 B1
Hold the baking tin (7) at an angle with the opening facing down over a wire cooling rack and
shake it gently. It should be easy to remove the bread due to the non-stick coating of the baking tin
(7). Do not use metal objects to remove the bread from the baking tin (7). The non-stick coating
could be damaged.
If the dough hooks (6) remain stuck in the bread, take them out using the dough hook remover
(10).

Maintenance / Cleaning

Maintenance
WARNING! Servicing is necessary if the automatic bread maker has been damaged
or if liquids or objects have penetrated the housing, if the automatic bread maker has
been exposed to rain or moisture or if it does not work properly or has been dropped. If
smoke is produced, or there are any unusual sounds or smells, switch off the automatic
bread maker immediately and remove the mains plug from the socket. In such cases, the
automatic bread maker should not be used until it has been inspected by authorised
service personnel. Only have qualified personnel carry out the maintenance work on the
device. Never open the housing of the automatic bread maker.
You can obtain information on spare parts via our service hotline. (see page 25)
Cleaning
DANGER! Remove the mains plug from the socket before cleaning as there is a risk of
an electric shock!
DANGER! The automatic bread maker must not be immersed in water! This poses a
risk of an electric shock and short circuit.
DANGER! Wait until the automatic bread maker has cooled down completely.
Otherwise, there is a risk of burns!
Device parts and accessories of the automatic bread maker are not dishwasher-proof. Do not use
any chemical, cleaning solvents or strong detergents to clean the automatic bread maker. You thus
avoid damage to the automatic bread maker and cleaning residues in the next breads.
To clean the device, proceed as follows:
16 - English