Gaggia BABY Dose Gebrauchsanweisung Seite 20

Using Coffee Pods
To use coffee pods, remember to only use the "Perfect crema"
pod fi lter (9).
Note: If present, remove the "Perfect crema" fi lter for ground
coffee (11).
1 Follow the procedure described under "Preparation".
2 Insert the frothing jet device (13) into the fi lter holder
(9). Then, insert the "Perfect crema" pod fi lter (10).
3 Place a container under the fi lter holder (9). Preheat the
fi lter holder by pressing the brew button (6) (this ope-
ration is only necessary for the fi rst coffee).
Water will start coming out.
4 Once 150 cc of water have been dispensed, press the
brew button (6) again.
5 After the warm-up, remove the fi lter holder (9) and
insert the pod. Make sure the paper of the pod does not
overhang the fi lter holder.
6 Insert the fi lter holder into the machine with a 45°
movement towards the left.
7 Rotate it to the right to tighten it into position. The fi lter
holder handle shall be perpendicular to the machine or
slightly tilted towards the right.
8 Place a cup under the fi lter holder. Press the button
corresponding to the stored coffee dose. Coffee will start
coming out.
9 On reaching the preset level (see "Coffee dose
programming"), the machine will automatically stop
brewing coffee. It is nevertheless possible to interrupt the
coffee brewing by pressing the previously selected button
(2 or 3).
10 Remove the cups and serve.
11 To brew more coffee, slowly remove the fi lter holder with
caution, moving it towards the left.
Make sure not to get burnt with water from coffee
grounds.
Once the fi lter holder has been removed, some water will
still drop.
This is due to the water pressure in the system.
Remove the pod from the fi lter. To brew more coffee,
repeat the procedure from step 5 to 10.
12 To brew coffee in manual mode repeat the procedure from
step 5 to 7 and place a cup under the fi lter holder.
Then press button 6.
Once the desired dose has been reached, press button
6 again to stop brewing.
Then proceed with steps 10 and 11.
Important note: Filters should be kept clean to
guarantee perfect results.
Clean daily after use.
If you experience a malfunction in the coffee brewing
process, leave the Filters in a metal container of hot
boiling water for 10 minutes, then rinse them in running
water and perform another brewing.
For a deeper cleaning of the fi lters, we recommend using
the cleaning tablets specifi cally designed to maintain the
effi ciency of the machine.
• 17 •
ENGLISH