Cleaning And Maintenance; Technical Specifications - HQ Power VDSABS8A Bedienungsanleitung

 Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
 Install the device in a location where few people pass by and that is unreachable for unauthorised persons.
 Make sure there is no flammable material within a 50cm radius of the device.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 Power button "1" on and "0" off
2 Power input jack
3 Low tone level control, 12dB raising attenuation at 100Hz
4 Hi tone level control, 12dB raising attenuation at 3.5 KHz
5 Volume control of RCA line input
6 Volume control of MIC input
7 Microphone ¼" input jacks, can receive unbalance signals
8 RCA (R.L) input jack, can receive both balance and unbalance signals
9 Line output ¼" jack
10 Input signal overload indicator
6. Operation
Refer to the illustrations on page 2 of this manual.
 Make sure the power switch is set to "OFF".
 Set the power switch to "ON". The device starts operating.
 Set the power switch to "OFF" to stop the device.
7.

Cleaning and maintenance

 All screws should be tightened and free of corrosion.
 The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections.
 The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
 Disconnect the device from the mains prior to maintenance activities.
 Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
 There are no user-serviceable parts.
 Contact your dealer for spare parts if necessary.
8.

Technical Specifications

power supply
power consumption
woofer size
tweeter size
amplifier
frequency response
sensitivity (1w/1m)
impedance
dimensions
total weight
inputs
output
V. 03 – 13/05/2013
VDSABS8A
115/230Vac 50/60Hz
max. 150W
8" (20.6cm)
1" (2.5cm)
100W (80Wrms)
45Hz-18kHz
96dB
8 Ohm
460 x 310 x 270mm
9kg
Line 1 MIC: 6.35mm jack /
Line 2: 2 x RCA
6.35mm jack
4 ©Velleman nv