Operation - YATO YT-2374 Originalanleitung

Before operation of the device may commence, please read the whole manual and keep it.
PUROPOSE
The purpose of the air engine cleaning gun is to clean surfaces with a compressed air jet and a cleansing agent. To clean surfaces
use solely biodegradable cleansing agents. Do not use infl ammable substances. The air engine cleaning gun is equipped with a
tank and a long nozzle, which permits to operate the tool even in hardly accessible places.
TECHNICAL DATA
Tank Operating
Catalogue
capacity pressure
number
[l]
YT-2374 0,85
SAFETY MEASURES
Never should the spray gun nozzle mouth be directed towards people – the coating materials or the compressed air may
cause injuries.
It is not permitted to use any other gas instead of compressed air. Application of other gases may cause serious injuries, a
fi re or an explosion.
Connecting the tool to the compressed air installation take into account the space required for the hose, in order to avoid possible
damage to the hose or couplings.
There should be an effi cient ventilation system at the workstation. Otherwise, there is a risk to health, as well as a risk of fi re or
an explosion.
The tool must be operated far from sources of heat and ignition, since otherwise there is a risk of damage to the tool or impairment
of its functioning.
Observe general safety regulations during work with coating materials and use appropriate personal protection means, such as
goggles, masks and gloves.
Never should an assembled pneumatic system be abandoned without supervision of an authorised operator. Do not allow children
close to an assembled pneumatic system.
High-pressure compressed air may make the tool recoil in the direction opposite to the thrust of the coating material. Great caution
should be exercised during work, since the thrust may, under certain circumstances, cause multiple injuries.
It is recommended to test the tool before the work commences. It is recommended that the employees operating the tool be
adequately trained. It will signifi cantly increase their safety.
Observe the instructions and recommendations of the manufacturer of the coating materials and apply the materials in accordance
with the specifi ed regulations on personal protection, fi re protection and environmental protection. If the instructions and
recommendations of the manufacturer of the coating materials are not observed, there is a risk of serious injuries.
If required, a list of materials used to manufacture the tool will be available in order to determine the compatibility with the applied
coating materials.
During work with compressed air the whole system accumulates energy. Caution must be exercised during work and breaks, in
order to eliminate the danger, which may be caused by the accumulated energy of the compressed air.
Never should the coating material jet be directed towards a source of heat or ignition, since otherwise a risk of fi re may
arise.

OPERATION

Commencement of work
Fill the tank with the cleansing agent and attach the tank to the cleaning gun.
Check the tightness of the compressed air supply system connections.
Blow the air supply hose before it is connected to the installation.
Before the cleaning gun is operated, make sure it has been cleaned and maintained properly.
Work with the cleaning gun
Adjust the pressure in the pneumatic system not exceeding the maximum operating pressure for the cleaning gun so as not to
damage the surface to be cleaned.
Direct the nozzle mouth towards the surface to be cleaned and press the trigger.
The jet is regulated by means of a rotary nozzle tip; once the jet has been adjusted the rotary nozzle tip should be secured
tightening the check nut located on the tip itself.
During work with the cleaning gun large quantities of dust and potentially harmful vapours may be generated, so it is necessary to
use personal protection means, such as goggles and masks.
O R I
Maximum air
pressure
[MPa] [MPa]
0,4 0,8
G I N A L
GB
Coating material Noise level L
fl ow (water) 14462)
[l/min.] [dB(A)]
130 < 70
I N S T R U
(EN
Vibrations
wA
[m/s ]
2
< 2,5
C T I O N
Weight
[kg]
0,46
5