Silvercrest SPU 900 A1 Bedienungsanleitung Seite 9

2. Press the button DOWN i to deactivate
the up-date function. The display g then
shows "UPDATE OFF".
3. Press the button UP o to reactivate the
up-date function.
Programme time for the slumber
function
1. Press the MODE/LOCK button e once
again. The display g indicates "SNOOZE
09".
2. Press the DOWN/UP i/o button to set
the desired time frame for the sleep func-
tion between 1 and 59 minutes.
Selecting 12 or 24 hour time display
1. Press the MODE/LOCK button e once
again. The display g indicates "24HR".
2. Press the button DOWN i to select the
12 hour modus. In the display g appears
"12HR".
3. Press the button UP o to return to the
24 hour modus.
Adjusting the projection duration
1. Press the MODE/LOCK button e once
again. The display g indicates "PROJ-T
OFF".
2. Press the buttons DOWN/UP i/o to
adjust the projection duration to between
01 and 59 minutes. When set to "OFF"
the projection lights up permanently and
can be switched on or off by pressing the
PROJECTION button a.
Automatic Display Dimmer
1. Press the button MODE/LOCK e once
more. The display g indicates "DIM-T
OFF".
2. Press the UP button o if the display is to
be automatically dimmed at specified
times. The display g then indicates "DIM-T
ON".
3. Press the DOWN button i to deactivate
this function.
Setting the Display-Dimmer Time
1. Press the button MODE/LOCK e once
more. The display g shows "DT 23:00 ON"
as the time at which the display is to be
automatically dimmed.
2. Press the buttons DOWN / UP i/o to
set a different time.
3. Press the button MODE/LOCK e once
more. The display g shows "DT 6:00 OFF"
as the time at which the display is to return
to its normal brightness.
4. Press the buttons DOWN/UP i/o to set
a different time.
Press the MODE/LOCK button e once
again to close adjustment.
Timer function
1. Press the button NAP/USER k. In the dis-
play g the NAP indicator appears and
the time indicator 010 blinks.
2. Using the buttons DOWN/UP i/o set the
desired time interval (a time span between
1 minute and 23:59 h is possible).
3. Press the button NAP/USER k once
again to start the Timer. In the display g
the remaining time is indicated.
4. Should the time be expired, the timer
signal will sound for about 10 minutes,
the NAP indicator flashes and the time is
displayed.
5. Press any button to end the alarm.
6. If you wish to end the Timer function
before the alarm, press and hold the
button NAP/USER k for one second.
Alarm function (Alarm 1 to 4)
You can programme in up to four alarm
times on your radio alarm. If a button is not
pressed within approx. 15 seconds, the ap-
pliance saves the adjustment and then leaves
the programming mode.
1. With the radio switched off, press the
PAGE/AL.SET button f to call up the
alarm function. Using the PRESET/ALARM
+/– buttons s/d, select the desired alarm
memory position. In the display g the last
set alarm time and the symbol for the type
of alarm (radio or signal tone) blinks.
2. Press the buttons DOWN/UP i/o to set
the desired alarm time. Pressing and hold-
- 7 -