Control Panel; Use - IPC PW-C40 New Elite 1813P T Bedienungsanleitung

USING
THE CLEANER

CONTROL PANEL

A - On/off switch
STARTING THE CLEANER
1) Turn on the water supply
tap (fig. 4A).
2) Connect the water cleaner
to the mains electricity supply
via the omnipolar switch or
by plugging the plug into the
socket.
3) Start the cleaner by turning
the selector switch to pos. 1
(fig. 6A).
!
Warning
The high pressure water jet
generates a reaction force in
the lance. Keep a firm grip on
the lance handle.
4) Press the trigger on the gun
and begin washing.
! Warning
In water cleaners with the
"Total Stop" system, the motor
starts and stops when the
lever on the lance handle is
actioned or released.
!
Danger
Do not block the handle lever
in the delivery position.
IMPORTANT!
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfunc-
tion (Fig. 7).
English
USING THE ACCESSO-
RIES.
The high pressure washer has
a nozzle with a flat angle jet for
cleaning large surfaces.
!
Warning
Aim the jet from a certain di-
stance to avoid damage cau-
sed by the high pressure.
ROTARY HEAD (optional
accessory)
FIG. 6
The high pressure washer
can be fitted with a head with rotary nozzle to clean the most
stubborn dirt.
!
Danger:
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
Do not aim the jet at people, animals or electrical sockets.
STOPPING THE CLEANER
1) After using with detergent, flush out the intake circuit; place
the detergent suction hose (fig. 8) in a tank of clean water and
let the pump run for 1 minute with the dosing tap turned fully
on and the lance in detergent delivery condition.
2) Stop the cleaner by turning the selector switch to pos. "0"
(fig. 6A).
3) Discharge the pressure from the H.P. hose by pressing the
trigger on the gun (fig. 5A).
4) Disconnect the water cleaner from the mains electricity
supply via the omnipolar switch or by unplugging the plug from
the socket.
5) Turn off the water supply tap (fig. 4A).
!
Warning
- If the water cleaner is left, even temporarily, turn it off by
using the omnipolar switch or by unplugging the plug from
the socket.
- Water cleaners with the "Total Stop" device should be consi-
dered as off when the omnipolar switch is in the "O" position
or the plug is unplugged from
the socket.
- When the water cleaner is not
used, close the safety device
on the handle (fig. 9).
- Dry use of the water cleaner
causes serious damage to
pump gaskets.
FIG. 7
- 22 -
FIG. 8
FIG. 9